Engine accessory drive belt can also be changed to see their own cattle force! – Sohu car-sunny came home

Engine accessory drive belt can also be changed to see their own cattle force! Sohu, a car – engine maintenance: engine accessory drive belt, the detection of the small take everyone to understand the role of engine accessory drive belt, the riders have reaction timing belt and timing chain has enough trouble, how they came out of the accessory drive belt? In fact, there is no need to worry about, although an important accessory drive belt, but did not detect and replace the timing belt high cost. If you do not want to worry about, in the case of the belt when the belt is also attached to the transfer, or. How do you determine the accessory drive from engine are respectively called flywheel end and attachment end, all accessories installed in the engine accessory terminal is composed of a two belt will all attachments connected to the crankshaft. As a result, the accessory drive belt acts as a bridge in a variety of sports. The accessory drive belt will have a tension device to adjust the belt tension, if the tension is too loose, usually in the running times will produce sharp sound, so when some cars at the start, with the sharp sound, is a problem of belt. If the accessory drive belt wear, then the system can not work properly, there may be slipping, abnormal sound, and even damage the engine, it is necessary to regularly check and maintain the accessory drive belt. Transmission belt tightness check the belt inspection process, the first task is to check the tightness of the transmission belt. Most engines are equipped with an automatic adjustment mechanism, and some of the engines adopt manual adjustment, but the regulator itself is automatic. Comparatively speaking, it is more feasible to judge the belt schedule by feeling. When the belt is stretched too much, the automatic tensioning device is loose or stuck, the tension spring breaks, which can cause the belt to loose. The sooner the problem is discovered, the easier it is to handle it. When the belt is loose or has not been engaged, it is necessary to reset the tensioning device or tighten the positioning screw. If the drive with a beating phenomenon, it should be replaced. If it is excessive tension, can make a mark with chalk or tape on the belt on the back, then turn the engine, check the drive belt, check whether there is wear with a wedge belt surface, whether there are cracks, the most important is to see whether there are traces of oil, grease or anti cold liquid wet traces. Because the accessory belt is used to realize the transmission of the friction between the two sides of the belt and the belt wheel. Therefore, the installation tension will directly affect the transmission belt using state: if the slip tension is too small will cause the belt slipping, not only increased wear on both sides of the belt, and slip the heat generated will accelerate the aging process of accumulation belt. Any of the above phenomenon, should be replaced in a timely manner, and it is best to find out the root cause of the problem. Of course, oil, anti cold liquid mark may be man-made, not caused by leakage. However, the transmission belt shell gasket seal, they will be leakage of liquid corrosion, and the transmission belt housing cover may also curl deformation, once there is oil, but also for non. The drive belt is generally replaced once every 60 thousand km, but due to the damaged process.相关的主题文章:

Comments are closed.